I installed Arduino 1.0.6, Teensyduino 1.2.1, Atmelstudio 6.2 and the current Visual Micro to work with a Teensy 3.1.
Those should fit together according what i have read.

I followed the steps from here
http://www.visualmicro.com/page/User-Guide.aspx?doc=Getting-started.html
and here
http://www.visualmicro.com/page/User-Guide.aspx?doc=First-steps.html.

If i choose Arduino 1.0 and Teensy 3.1 from the Visual Micro Menu, my sketch seems to be compiled, but fails to upload.
I get the followin g message:

"Uploading to I/O board using 'COM4'"
"avrdude: stk500_getsync(): not in sync: resp=0x00"

The path in the configuration manager is set to C:\Arduino\.


If i choose Teensy 1.0 from the Visual Micro Menu, i cannot chose a board (pulldown list is empty).
When i try to compile, i get this message:
"Unable to locate configuration data for this hardware. Please confirm you are using the correct ide (.exe) location"

I set the Path to "C:\Arduino\hardware\teensy" in the configuration manager, where the the boards.txt is located.
The teensyduino  itself is in the path C:\Arduino\hardware\tools.

Maybe it's a small step to the solution, but im completely lost.
It would be great if somebody could help. 
Best regards

Thanks for the email.

Do you still have a blank boards list or is is that just the compile now fails?

I think I see. You are saying the output was when you used the Arduino 1.0.x application in Visual Micro instead of the Teensy 1.0 option?

Please send two screenshots of from the Ide Locations tool so that I can compare the paths you have added for Arduino 1.0.x and Teensy 1.0

If you are sure the path is correct for teensy 1.0 ide, then you can enable the trace in tools>options>visual micro>user interface>trace. Then restart the ide and when it lands a trace will appear in the output window area. Please copy and paste into an email. 

Visual Micro does the same thing to load each ide. For Teensy all it does different surrounds intellisense, so the fact that the Arduino 1.0.x ide builds okay with Visual Micro but the same Ide registered against Teensy 1.0 fails suggests it is just the ide location that is wrong. So seeing the Teensy 1.0 ide locations config along with the one you have for Arduino 1.0.x will be clear for me.

Thanks

Okay thanks for the screen shots. 

You seem confused about what to enter into the ide locations paths I will have to look at Visual Micro to try to understand what led you to this confusion.

The different application options in Visual Micro just change the way intellisense works slightly which is what I said earlier. However in the case of 1.0.6 you are using the same ide for both Teensy 1.0 and Arduino 1.0 in Visual Micro. Two views into the same Ide.

You sent me 3 screenshots where you have used 3 different paths. Only 1) is right. 

1) c:\arduino
2) c:\arduino\tools
3) c:\arduino\teensy

The Visual Micro Ide Location window expects a location of where the arduino.exe (or other ide exe) is installed.

In your case I think you have assumed that when you install Teensy it installs a new Ide. It does not. It uses a standard Arduino.exe Ide and simply adds some new board and hardware definitions required during compilation.

So change your Teensy path in Visual Micro to be the same as the one you have used for the working Arduino 1.0 option which is c:\arduino

Great I will change the docs thanks. The Teensy Ide is the Arduino Ide so I will make it clearer

And removing some old instruction from Visual Micro 2 years ago